Im use your workaround method because the transistor/resistor dont work for me I solder the cables coming from the ATX Psu to the 4 pin PS 4 Slim cable like That: The PS4 slim starts just up in the safe mode, and when I do a software update when the First Step is finished, it says the playstation start new to install the update, then it shuts down but it don't starts up again too install the update, and when I press the ps button again in the safe mode nothing was happening, no update nothing. It's me again Finalman from the 2 post from 19.december 2:02am and 3:08am Try an auto\electronics shop for these.Īs for the resistor and transistor diagram you are to solder the three output lines (PWR ON, GND and ACDC_STBY) to the corresponding pins on the PC power supply (PWR ON and GND) and PS4 (ACDC_STBY) motherboard. If you can't find or acquire the main 2 pin power connector you can use cable lugs that fit snugly onto the PS4 power prongs. To get the 2 pin main power connector try yo get an old faulty PS4 supply then desolder the connector. To get the PS4 4\5 pin power cables look on eBay\aliexpress\etc for them. The PS4 to adaptor cable connection you will either have to solder directly to the motherboard (not recommended) or make the adaptor cable up with PS4 cables soldered on their ends (my preferred method). If you don't have a faulty power supply ask at your local PC repair shop you should be able to get them for free. The adaptor cable wires can be cut from an old preferably faulty PC power supply. To get the male atx 20\24 pin connector for the adaptor cable you can get it used off of an old PC motherboard using a heat gun to remove it or buy it new off of eBay\Aliexpress\etc.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |